SCI-BOP-SO Slide Over Base

Construction

The slide-over base and mid-section shall be made from cast ASTM A48, Class 30, cast iron  construction. The pole shall be made from 3 1/2” Schedule 40 steel pipe (Ø4” OD).

One (1) access door in the base (9” x 6” minimum opening) shall be secured with stainless steel hardware.

One (1) hand hole in the pole (3” x 2 1/2” minimum opening) shall be secured with stainless steel hardware.

Accepts Ø4” pole.

Luminaire Mounting

A Ø3” by 3” tall tenon shall be an integral part of the pole provided for post top mounting of the luminaire.

Installation

Base to be slid over pole, mid-section then secured to slide-over base using (3) stainless steel set screws. Removable mid-section incorporates groove locking feature. The lighting pole shall be provided with (4) Ø3/4” x 24” long ”L-Type” anchor bolts. Each anchor bolt shall be supplied assembled with (2) nuts, (2) flat washers and (1) split lock washer. The pole shall have a Ø11” bolt circle and requires a 3” anchor bolt projection. All anchorage hardware shall be fully galvanized.

Finish

The base and pole shall be finished with a high performance coating achieved with a three step paint process. An acid etching industrial wash primer, two part epoxy base primer, and a finish coat that is a two-part aliphatic acrylic polyurethane. Paint shall be weather, corrosion, abrasion, and UV resistant in compliance with the Society for Protective Coatings SSPC-36 (level 3) paint standard. Color to be specified.

ProductZoom